View Single Post
Old 08-16-2013, 12:20 PM
dodge dude94's Avatar
dodge dude94 dodge dude94 is offline
Motorized Bicycle Elite Member
Join Date: Jun 2012
Location: East Texas
Posts: 1,017
Default Re: what did you do to your motor bike today?

Originally Posted by crassius View Post
I've seen these with 1.0 thread on one end & 1.25 thread on the other end, also 1.25 on both ends, and 1.25 interference thread (which one might expect for head studs) on just the top end. Makes mixing & matching quite a task.
I just need to know if the nuts are fine thread or coarse thread. Because I bought fine thread thinking that's what it was and they didn't work. And they matched up to the nut chart that the store has where you screw your hardware in and match it to the one that it...well..matches. lol

Had an oh sh1t moment just now.

Went to pull the clutch and there was no clutch. lol
Screws vibrated out of the clutch cover. Only had one screw in. So I had to ride like a madman to get home as I couldn't stop. lol
2 WHEELS: '11 Huffy Good Vibrations, '11 Skyhawk GT5, 44t, CNSV2, NGK BPR7HIX, Bosch wire, shutupexhaust, 26x1.75kevlar tires, Tektro C230's, new stupid Bell chain
Reply With Quote