View Single Post
Old 07-30-2013, 11:38 AM
mapbike's Avatar
mapbike mapbike is offline
Motorized Bicycle Elite Member
Join Date: Mar 2010
Location: Central Texas
Posts: 5,379
Default Re: Standard upgrades for Motorized Bicycles?

Originally Posted by Master-shake View Post
Thats a good one to use, I have gotten some from motion industries and have run them with no issues, but the one from are wider at 15mm and to up the room between the con rod and piston better, just remember if you change it out just oil it good with a bit of 2 smoker oil when you install it and then it wont start off dry the first couple of seconds the engine fires off.

Here is another place that offers some nice upgrades, nice gaskets and a few other things like a upper wrist pin bushing for those who would rather have it over a bearing.

I dont always ride WOT, but when I do..I do my best to keep the rubber side down..Ride safely my friends!
Reply With Quote