View Single Post
Old 07-04-2013, 06:54 PM
mew905's Avatar
mew905 mew905 is offline
Motorized Bicycle Elite Member
Join Date: Sep 2012
Location: Moose Jaw
Posts: 647
Default Re: easy clutch pull mod

innovative, but not to knock your ideas but my stock clutch isnt exactly hard to pull either, all I did was align the cable guide properly, it has a straight arm actuator, and I didn't use the "return spring", only the heat shield. that setup tends to disengage my clutch if I rest my hand on the handle (it has alot of wiggle), which is normally how I ride so I'm prepared to pull the handle just in case something happens.

However anything better than the stock setup is appealing, I considered buying one of these myself, because I lack fabrication skills, but I've never had a clutch that was remotely difficult to use once I figured it out.
Skyhawk GT-5, Dax RT, RSE Reeds, Jag CDI, Drilled stock exhaust, Puch Hi.
List of HT hardware === Stop four-stroking!

Last edited by mew905; 07-04-2013 at 07:08 PM.
Reply With Quote