Thread: Hello
View Single Post
Old 05-25-2013, 10:02 AM
KCvale KCvale is offline
Motorized Bicycle Elite Member
Join Date: Feb 2010
Location: Phoenix,AZ
Posts: 3,551
Default Re: Hello

Hi Tiny,
Here is a tip for center mount electrics, use muffler clamps to hold your motors flat mount plate to the round seat post for a good hold, and give your plate enough room on the short L side to easily get to the U bolt nuts, I used some angle steel I had laying around.

That's my trike but the same motor mount setup for a 2-wheel.

I don't know if you have seen the Cyclone and SBP kits mount but the short side of the L was so short you couldn't get to the bolts and it was flat steel against round steel with 2 lame 'universal' V shaped brackets that moved so bad they actually put set screes in them to keep the motor from twisting and moving down which of course didn't fix the problem.
KC's Krusiers Builds
Reply With Quote