View Single Post
Old 12-05-2008, 11:17 PM
conradcliff's Avatar
conradcliff conradcliff is offline
Motorized Bicycle Senior Member
Join Date: Oct 2008
Location: Tampa, Fla.
Posts: 67
Default Re: GXH50 and a pocket bike clutch?

Well, I just found this and it has me worried again..

If the mounting holes on the Titan are 75mm center to center then this presents me with a problem..

If the bell housing would still fit then I could probably drill the holes out and use some washers to hold it together.

Any ideas?

Edit: Ok, I don't know why I thought someone had told me that the mounting holes on the Titan were 75mm center to center but I just found this which says they're only 70..which is close enough for me

Last edited by conradcliff; 12-06-2008 at 12:12 AM.
Reply With Quote