Well, last update was before xmas, oops, sorry guys. During winter I couldn't really do too much with it. Anything I didn't want to freeze while doing anyway. But now, birds are chirping, welders humming, grinders shutting the birds up
Added a couple of stay supports like this new cruiser frame
, but a bit longer(idler pulley tab will mount to it. Also added couple of tabs under the dropouts for a single wheeled trailer in the works.
The angle of the pic is weird, but they are the same length between the stays:
Closer shot, the tabs are just 1/8 plate cut to match the dropout with a grade 8 welded on both sides:
I'm still cleaning up welds, getting ready for primer, etc... But some progress is better than no progress eh?