View Single Post
Old 12-02-2008, 09:26 AM
jasonh's Avatar
jasonh jasonh is offline
Motorized Bicycle Elite Member
Join Date: Jun 2008
Location: Longmont, CO
Posts: 1,590
Default Re: Chain and alignment questions...

if you don't have a good chain breaker, you can place the link over a small (1/4-1/2") gap between two 2x4's. Then take a hammer and awl/punch/screwdriver and knock out the pin.

You can run without the tensioner, but it requires getting your chain to a good length, and then putting spacers between the rear motor mount and the motor to tighten it up.
Reply With Quote