Thread: new to forum
View Single Post
Old 04-22-2013, 02:39 PM
travis dasher's Avatar
travis dasher travis dasher is offline
Motorized Bicycle Newbie
Join Date: Apr 2013
Location: California
Posts: 18
Default Re: new to forum

I have a Phat cycles cruiser with Ape hangers and 80cc motor kit. I got it all installed yesterday. Took it for shake down cruise and chain tensioner slipped into spokes, snapping one, and off rear sprocket and chain rubs on the tire also. Got the tensioner removed and the chain is binded in the drive gear. Luckily I was only 100 yards from my house. So now I have to get the chain out, widen the rear so chain does not rub and fab a chain tensioner. Going to use the metal stock with conduit clamps mounted to upper and lower part of frame with roller bolted on. Got some ideas from the chain tensioner sticky thread. If this does not work I am going to move everything over to my Kona Scrap mountain bike. Up until the chain tensioner slipped the bike was fun to ride. Hopefully I get this figured out.
Reply With Quote