Thread: would it work?
View Single Post
Old 04-16-2013, 08:06 PM
Dan's Avatar
Dan Dan is offline
Join Date: May 2008
Location: Moosylvania
Posts: 11,850
Default Re: would it work?

Howdy RDog, welcome.

A few folks have built with that engine and torque converter/CVT. There are a few issues you would have to address and you should do a search. (above) Lots of workarounds and ideas. It is a complicated build but very doable.

2 main problems are the PTO on the engine is 5/8 and the receiver for the torque converter/CVT is 3/4. Also, the torque converter/CVT is very wide. But folks have done it.

The bike looks like it has more then enough room but you want good front and rear brakes.

Best of luck and post lots of pics!
worst apocalypse ever

Last edited by Dan; 04-16-2013 at 08:11 PM.
Reply With Quote