View Single Post
Old 11-29-2008, 12:33 PM
Creative Engineering Creative Engineering is offline
Join Date: Sep 2008
Location: Clearwater, FL
Posts: 1,668
Default Re: Creative Engineering's clutch actuator



If you are going to have a problem I can mill down the face of the housing to be flush with the mag cover. I left the actuator housing 1/16" thicker for strength. The bike we have here has over 1/2" of clearance between the housing and the pedal crank. I didn't realize that some come real close. In order to take 1/16" off of the outside face, the cam hole will have to be moved inbound 1/16" which wil require a different length pin...,(It is supplied in the kit). We have housings that have not been drilled for the cam so it would not be a problem.

Reply With Quote