View Single Post
Old 11-29-2008, 07:33 AM
Bikeguy Joe Bikeguy Joe is offline
Godfather of Motorized Bicycles
Join Date: Jan 2008
Location: up north now
Posts: 11,531
Default Re: Creative Engineering's clutch actuator

I used the shorter of the two pins, then I kept tweaking the arm placement to get the disengage point just right.

No grinding was needed....well, I did de-burr the edge just a tiny bit.

Also, in the directions Jim, it states that the return spring will be needed, if I read that part right. I am not usuing it since I took a little extra time setting it up, but is it really needed? I know the cam has a little less force (return direction) than the old flat plate deal, but it seems to return sufficiently for me. As stated, I haven't actually run the bike, but the engage/disengage seem to be fine as-is.

Reply With Quote