Re: Tons of HT motors in a warehouse:
Wow that was a short clip! 6 seconds doesn't really justify what they are doing, but its obvious they are tapping in a crankshaft seal into place on the right side (clutch) case. The only improvement I could see is to use a block of wood or a drift punch turned to fit the seal and tap it into place. What's wrong with the assembly method used there? If you put in 100,000 seals I pretty sure you would figure out how to do it fast and cheap. That is the name of the game in China. No one said it is pretty.
Last edited by UVsaturated; 03-17-2013 at 07:32 PM.