Re: Where to find lead sheets cheap
Here's two more.
I used the PC-7 to "glue" the sheet in place, and also because the angle between the two tubes was larger than the mount. I filled the void with the PC-7 instead of causing a pressure point- mostly at the front mount. (something I am convinced also causes a lot of vibrations in these bikes...frame angle/mount discrepancies)
You can't see the lead between the "c" mount and the frame, because it's not there. I removed the clamps after the PC-7 set, and installed the lead sheets before replacing them.
Photo no. 2 is the front mount.
Last edited by Bikeguy Joe; 11-20-2008 at 05:32 AM.