Thread: Rag Joint Issue
View Single Post
Old 12-07-2012, 02:59 PM
Groove's Avatar
Groove Groove is offline
Motorized Bicycle Elite Member
Join Date: Nov 2012
Location: Lexington, KY
Posts: 245
Default Rag Joint Issue

I apologize if this topic has been covered in the past.

I received this instruction from the ebay seller when I inquired about the sprocket and rag joint I just received (the picture shows the nice overlapping that should be achieved during installation)

"....try overlapping the pieces.. it should work that way..."

The funny thing is, even just laying the three pieces in a circle the holes don't even line up with the sprocket holes...

<Groove rolls eyes, flips table, storms out of room>
Attached Images
File Type: jpg Overlapping Suggestion.jpg (465.0 KB, 80 views)

Last edited by Groove; 12-07-2012 at 03:29 PM.
Reply With Quote