Originally Posted by fatdaddy
Before I even install any chinese 2 stroke I make very sure all the points that need grease get grease. i.e. clutch and bevel gear, clutch arm, Bucking bar and bearing, ect. Then I run very heavy on the mix for break in. Even after that I run 3 1/2 or 4 oz, 2 stroke oil per gallon.(I use the cheap stuff,) I know it's a little heavy, but like I said, I've NEVER blown an engine.
I've done pretty much the same a so far so good! 4oz oil in 1 gallon is a 32:1 mix, that is what I run all the time and consider it a standard mix. The motor runs good on it, doesn't smoke up the place and seems to have enough lubrication...