View Single Post
Old 10-01-2012, 01:59 PM
bigbutterbean bigbutterbean is offline
Join Date: Jan 2011
Location: Lebanon, PA
Posts: 2,420
Default Re: Help with handlebars

Originally Posted by scotto- View Post
Whenever I used the cheap plastic throttle, I'd drill a small hole in the bars where the nub would go......then drill through the plastic housing of the throttle (where the alignment nub is) and drive a sheet metal screw through the housing into the hole in the bars. Done deal....throttle stays put.

Did I mention that I ride at WOT alot? Thus the reason for securing the cheapo plastic junk throttle.
I put an old exhaust stud through mine. works good.
Reply With Quote