View Single Post
Old 10-01-2012, 01:12 PM
scotto-'s Avatar
scotto- scotto- is offline
Custom 4-Stroke Bike Builder
Join Date: Jun 2010
Location: Ridin' inSane Diego, CA.
Posts: 6,504
Wink Re: Help with handlebars

Whenever I used the cheap plastic throttle, I'd drill a small hole in the bars where the nub would go......then drill through the plastic housing of the throttle (where the alignment nub is) and drive a sheet metal screw through the housing into the hole in the bars. Done deal....throttle stays put.

Did I mention that I ride at WOT alot? Thus the reason for securing the cheapo plastic junk throttle.
EZ Motorbike Dealer - San Diego, CA.
Nothing is out of my realm,
if it doesn't fit, make it fit! Beer is the answer....what was the question?
A sense of humor costs nothing, why don't people use them more often?
"You can't buy have to earn it"

Last edited by scotto-; 10-01-2012 at 01:16 PM. Reason: WOT
Reply With Quote