Re: My new clutch actuator
Ok, I gave it a shot today. I couldn't get it to work right. I need to get a spring to get it to return to the engaged state. I think it'll work ok after that. The lever pin and "housing" are machined so close I feel a bit of drag just turning it by hand. I might put the pin in a drill and run it through some 600 grit paper, see if I can knock off whatever is causing the drag.... Then try it again. Probably next year... All in all it's a hellofa kit for $30...
Kings 70cc 3200+ miles. Now on a Schwinn Point Beach NOW in mothballs..