View Single Post
Old 04-21-2012, 11:58 AM
Al.Fisherman's Avatar
Al.Fisherman Al.Fisherman is offline
Motorized Bicycle Elite Member
Join Date: Sep 2009
Location: Calera, Alabama
Posts: 1,966
Default Re: Unknown bikcycle engine part

Originally Posted by Maskot View Post
where do I mount it and how do i use it, never seen this before, must be the new carburetor
Anywhere you want to...most install it on the handlebar. When the engine is COLD you may need some choke (restricting air flow through the carburetor), Rotate the lever counter clockwise (about 1/2 way to start), then when the engine is warmed up, rotate the lever fully clockwise (no choke).

Truthfully....With your little knowledge of a carburetor, it most likely be best for you to purchase a NT or a NT speed, and sell your CNS to cover your expanses. I have over 50 years experience (can't tell how many I've rebuilt) with carburetors, and I wouldn't want to fool with a CNS, when a NT works fine.
Looking for HT's parts?
HT pre instillation tips.
Engine running problems?
HT breakdown Photos

Ron ><)))))*> Calera, Alabama

Last edited by Al.Fisherman; 04-21-2012 at 12:07 PM.
Reply With Quote