Hi guys,
While I'm waiting on some torx bits to get the plastic housing off my trimlite weed eater 25cc engine I want to run my psuedo design by you guys and see if you can give me any advice or similar.
What thickness metal do you recommend? This seems to be the easiest design I can do right now becuase it requires no drilling into the frame. I plan to put a bmx peg on the shaft. I'm going to go friction drive and this is my first build. I cannot fit a 2 stroke in my frame and I'm a little tight on money. I have this weed eater engine lying around so I might as while put it to use!
The bike with it:
http://i.imgur.com/TIcAU.jpg
Regular:
http://imgur.com/ElOhW
While I'm waiting on some torx bits to get the plastic housing off my trimlite weed eater 25cc engine I want to run my psuedo design by you guys and see if you can give me any advice or similar.
What thickness metal do you recommend? This seems to be the easiest design I can do right now becuase it requires no drilling into the frame. I plan to put a bmx peg on the shaft. I'm going to go friction drive and this is my first build. I cannot fit a 2 stroke in my frame and I'm a little tight on money. I have this weed eater engine lying around so I might as while put it to use!
The bike with it:
http://i.imgur.com/TIcAU.jpg
Regular:
http://imgur.com/ElOhW