View Single Post
Old 02-27-2012, 08:09 AM
darkhawk22's Avatar
darkhawk22 darkhawk22 is offline
Motorized Bicycle Elite Member
Join Date: Aug 2010
Location: Acworth, GA
Posts: 733
Default Re: Pull Start for 80cc chinese engine


Ok so I removed the lock nuts and washers on the Magneto and re-installed the Pawl and it spins freely now with no additional spacing needed. I secured it with the supplied nut, no lock washer then reattached the outer housing with pull assembly. Same thing happens it still pulls out easily (just compression from engine) but does not retract. I maybe have to do as Hiker says and use a thinner nut to secure the Pawl.
Currently no bike but thinking about starting a new build soon.
Reply With Quote