View Single Post
Old 02-26-2012, 02:37 AM
corgi1's Avatar
corgi1 corgi1 is offline
Motorized Bicycle Elite Member
Join Date: Aug 2009
Location: KCMO
Posts: 2,282
Default Re: Pull Start for 80cc chinese engine

Originally Posted by hiker472 View Post
It sounds like there's just enough pressure on that from that lock nut. If you remove the screws, holding it on, just enough to loosen it and give it more freedom, and it works OK, then there is too much pressure on that pawl. Put something thinner in there instead or remove the lock nut altogether and see if that makes a difference.

If it does stick out just far enough and you don't want to remove the lock nut, you could always grind a little metal off the spinner thing.
am I understanding the lock washer is under the sheetmetal piece or under the nut?
and yes, It's as bad as you think and they are out to get you.
Political Correctness:
A doctrine fostered by a delusional, illogical liberal minority, and rapidly promoted by an unscrupulous mainstream media, which holds forth the proposition that it is entirely possible to pick up a turd by the clean end.
Reply With Quote