View Single Post
Old 02-24-2012, 01:48 PM
darkhawk22's Avatar
darkhawk22 darkhawk22 is offline
Motorized Bicycle Elite Member
Join Date: Aug 2010
Location: Acworth, GA
Posts: 733
Default Re: Pull Start for 80cc chinese engine

I just received a pull start kit from Pirate Cycles and when I went to install it I noticed that I had a lock washer and then a nut on the shaft. I removed these leaving the lock washer on then putting the metal part as it should go securing with the original nut. The Pawl as it looks like it's called moves freely and does not hit the magnet screws as it is far enough off thanks to the original lock washer. However; when I complete the install and pull the cord out, it refuses to go back in. Any ideas? When I take the main cover back off the cord retracts as it should.
Currently no bike but thinking about starting a new build soon.
Reply With Quote