View Single Post
Old 01-26-2012, 08:11 PM
cannonball2's Avatar
cannonball2 cannonball2 is offline
Motorized Bicycle Elite Member
Join Date: Oct 2010
Location: Colonial Coast USA.
Posts: 3,286
Default Re: First build (Worksman)

Originally Posted by cat341 View Post
Received the Worksman coaster brake wheel and attempted to installed the rag joint and sprocket (learned that I needed to grind down the dust cover to get the sprocket to sit properly on the hub....I found that thread and it worked) funny thing about the three half moon backing plates they seem to overlap by about 1/8 -1/4 of an inch????...ok what am I doing wrong? I removed the sprocket and put it all together off the wheel to get a better look (see photo) but they still overlap. AM I going to have to grind down each one in order for it to fit properly?
**I had to use my old camera to get smaller size photos to post directly onto the thread.
When you put them on the wheel and start the tightening sequence they will butt together with a little prodding from a screw driver.
Reply With Quote