View Single Post
Old 01-12-2012, 03:33 PM
Mozenrath Mozenrath is offline
Motorized Bicycle Elite Member
Join Date: Jan 2011
Location: California
Posts: 340
Default Re: Gear puller tool stinks!

The threads on the end of the tool appear to be worn down, and I think that is most of the problem. I'm just not sure I want to spend money and time on another tool if it sucks as much as the one that came with my kit.

The thread locker didn't work, although that's because I think it was crappy thread locker. It wasn't Loctite brand, and when I came back hours later it was still wet!!!! My impression was that this was an adhesive bonding agent. I'm still very tempted to JB Weld that sucker into the gear. Depends on if it holds stronger than the gear does to the shaft.
Reply With Quote