View Single Post
Old 01-06-2012, 10:29 AM
Al.Fisherman's Avatar
Al.Fisherman Al.Fisherman is offline
Motorized Bicycle Elite Member
Join Date: Sep 2009
Location: Calera, Alabama
Posts: 1,966
Default Re: cheap entry level welder ????

Originally Posted by Greg58 View Post
I have a cambell Hausfield 110v mig that looks just like the HF welder, I use flux core .035 wire and it does well on thicknesses up to 1/4 . I also have a sears dual range 220v stick welder I use on heavier metal. Hey Al does your welder have the adjustment with the knob you loosen and move the plate under to the desired heat range? I know that sounds strange, even harder to explain but has been a very good machine.
Mine looks exactly like this... When I bought it at a warehouse sale, I had to take it apart and straighten out the fan was hitting the case...Not bad for $60.00 new.
Attached Images
File Type: jpg welder.JPG (36.0 KB, 49 views)
Looking for HT's parts?
HT pre instillation tips.
Engine running problems?
HT breakdown Photos

Ron ><)))))*> Calera, Alabama

Last edited by Al.Fisherman; 01-06-2012 at 10:33 AM.
Reply With Quote