View Single Post
Old 12-14-2011, 10:24 PM
OG-Whizzerdude's Avatar
OG-Whizzerdude OG-Whizzerdude is offline
Motorized Bicycle Elite Member
Join Date: Nov 2011
Location: Blythe, CA
Posts: 128
Default Re: Tinsmith's saddle how to...

I wish I would have read this before I did my seat. I was going for the bobber look so I used a banna seat from Italy. That pan was modifed to bend up where it hits the chopped fender. I was lucky enough to let my wife take me to a thrift store. I found a childs wet suit with gel pad knees and a womans leather jacket, cheap. I used a black and Decker knealing pad. I put the pan inside the leg of the suit and cut to length. Super glued it under the pan. Then I cemented the B&D pad to the suit with gel pad in optimum position for the buns. Stuck that assembly into the arm of the jacket, trimed and glued.

Last edited by OG-Whizzerdude; 12-14-2011 at 10:29 PM.
Reply With Quote