Thread: Yong Xing
View Single Post
Old 09-24-2008, 07:06 AM
Nomad Nomad is offline
Motorized Bicycle Elite Member
Join Date: Aug 2008
Location: U.S.A.
Posts: 188
Default Re: Yong Xing

Anthony, remove the spark plug, remove the clutch actuator (3 screws) and use a 19mm socket wrench to rotate the front sprocket, start the chain on the bottom of the sprocket. The instructions show both rubber gaskets on the same side of the spokes, I think you will find that most on here suggest that this is incorrect, "sandwich" the spokes between the rubber gaskets, and IF you can CUT the gaskets with a SCISSOR get different ones.... you will need a stout sharp knife to cut only one gasket for the "inside of the spokes"..... good luck
Reply With Quote