View Single Post
Old 11-15-2011, 06:23 PM
wayne z's Avatar
wayne z wayne z is offline
Motorized Bicycle Elite Member
Join Date: Dec 2010
Location: louisiana
Posts: 1,746
Default Re: Air Pneumatic Nibbler and Cutter

Most air tools use a lot of cfm to work. I'm not familar with that tool, but thet usualy have the cfm needed listed in their manual or ad.. You could get by with a 6 cfm compressor with a large tank for short intermittent work. For continuos work, around 12cfm would be better.

These Cfm I'm talkin about are the high pressure rating cfm. That's where the work's done. Most any compressor output higher cfm at low pressure in their brochure's nomenclature.
Reply With Quote