View Single Post
Old 11-06-2011, 01:25 PM
happycheapskate's Avatar
happycheapskate happycheapskate is offline
Motorized Bicycle Elite Member
Join Date: Nov 2009
Location: Rockwall TX
Posts: 1,992
Default Re: what did you do to your motor bike today?

Try this one , made for 2 cycle outboard engines

Originally Posted by Dirt Road Cowboy View Post
Thanks Dave.

I did replace the plug. O'Reilly didn't have the NGK, so I got a Champion. The plug wire has been replaced from a working Chevy motor that I have, so I know it works.

I'm going to pull the plug and check for spark. I used my ohm meter and checked the magneto, and it checked out OK. The old CDI had no continuity between either of the wires and the plug wire, so I bought another one.

I'm going to reduce the plug gap and see if it may just have a weak spark, and I'll go from there.
1" roller Dax Friction Drive and Tanaka 3300 with mods.
Reply With Quote