View Single Post
Old 10-25-2011, 04:02 PM
Al.Fisherman's Avatar
Al.Fisherman Al.Fisherman is offline
Motorized Bicycle Elite Member
Join Date: Sep 2009
Location: Calera, Alabama
Posts: 1,966
Default Re: First build: Genesis Onyx 29" cruiser

Originally Posted by 6killer View Post
Hey Ron what is the best way and tool to trim the dust cover...thanks
I feel this is the best, others may not agree. I don't trim the dust cover, I enlarge the hole in the sprocket. I use a drill press, a ream and 2 clamps. This way when I place the sprocket over the dust cover it is centered. Some use a Dremel tool, but I wanted to keep the dust cover intact... why? to do its intended job. Contact me at motorbicycle00@gmail and I'll forward what I just sent to a member about the same question. Bevel the teeth on both sides while you are at it. Helps on chain alignment with the sprocket.

Milling hole in sprocket....
Looking for HT's parts?
HT pre instillation tips.
Engine running problems?
HT breakdown Photos

Ron ><)))))*> Calera, Alabama

Last edited by Al.Fisherman; 10-25-2011 at 04:28 PM.
Reply With Quote