View Single Post
Old 10-22-2011, 02:35 AM
geoldr geoldr is offline
Motorized Bicycle Elite Member
Join Date: Jun 2011
Location: California
Posts: 260
Default Re: Some help with centrifugal clutch install

Hey guys. Just got some free time, I can combine the videos and upload to youtube some later time tomorrow hopefully. But here are the fitment pictures I was talking about. I have a 10 mm socket, which seams to be the exact size of the crankshaft.

The first image displays the socket as far as it will go in the standard gear. It goes in all the way without issue, because there isn't any taper.

The second image displays the same socket, but now in the CC. All the way it can go.

The third image displays the difference in fitment. The top notch is how far the standard gear will go, and that's all the way inside. But the lower notch, is how deep the CC clutch goes and stops. So it's only in half way!

I have a feeling that even with the woodruff key, this still isn't exactly safe.

What do you guys think? And what should be my next best course of action to take?
Attached Images
File Type: jpg photo.JPG (96.8 KB, 62 views)
File Type: jpg photo2.JPG (84.8 KB, 69 views)
File Type: jpg photo3.JPG (90.4 KB, 59 views)

Last edited by geoldr; 10-22-2011 at 02:40 AM.
Reply With Quote