View Single Post
Old 10-19-2011, 12:50 PM
rohmell's Avatar
rohmell rohmell is offline
Motorized Bicycle Elite Member
Join Date: Jun 2010
Location: New York
Posts: 1,533
Default Re: Some help with centrifugal clutch install

The gear puller will screw in about 3 turns, then it is getting close to bottoming out in the gear. At that point, forcing any more turns could strip the threads.

Put some grease on the threads and screw it in and out of the gear by hand several times, you will find the it will screw in further and further, and then no further. Stop at this point and screw in the inner piece and use a wrench to turn the inner piece and the gear will pop off.
Reply With Quote