View Single Post
Old 10-13-2011, 11:56 PM
MotorBicycleRacing's Avatar
MotorBicycleRacing MotorBicycleRacing is offline
Motorized Bicycle Elite Member
Join Date: Jul 2010
Location: SoCal, Orange County.
Posts: 5,353
Default Re: Really? Gear remover tool wont fit

Originally Posted by geoldr View Post
Yup, that's how I am trying to do it...

Here is an image. Not sure if you can tell much. But i figure the side on the left screws into the space in the small gear. But its too small! Ill try again tomorrow after work. Maybe my angle was off, but I swear it didn't fit.

Im in the Bay Area in Pleasanton in CA
You are using the wrong end and you have to
remove the screw before you can thread the puller into the gear.

The small end of the puller goes into the gear.

Last edited by MotorBicycleRacing; 10-14-2011 at 12:00 AM.
Reply With Quote