View Single Post
Old 10-13-2011, 11:29 PM
MotorBicycleRacing's Avatar
MotorBicycleRacing MotorBicycleRacing is offline
Motorized Bicycle Elite Member
Join Date: Jul 2010
Location: SoCal, Orange County.
Posts: 5,353
Default Re: Really? Gear remover tool wont fit

Originally Posted by geoldr View Post
Hey guys, so I am trying to prep for my centrifugal clutch install tomorrow. I found my gear puller tool, but as luck would have it, it doesnt actually fit onto the small gear. Its a little bit too small. Ill post a picture in an hour or so. But, theres no way I am doing it wrong right? It just screws right on?
Yep, it screws right in.....
I got a box of those pullers. Some of them have messed up threads
but never seen one that was too small.

Where are you in CA?
Reply With Quote