View Single Post
Old 10-13-2011, 11:19 PM
geoldr geoldr is offline
Motorized Bicycle Elite Member
Join Date: Jun 2011
Location: California
Posts: 260
Default Really? Gear remover tool wont fit

Hey guys, so I am trying to prep for my centrifugal clutch install tomorrow. I found my gear puller tool, but as luck would have it, it doesnt actually fit onto the small gear. Its a little bit too small. Ill post a picture in an hour or so. But, theres no way I am doing it wrong right? It just screws right on?
Reply With Quote