Thread: Carb assembly?
View Single Post
Old 09-14-2008, 09:39 AM
hill climber hill climber is offline
Motorized Bicycle Elite Member
Join Date: Sep 2008
Location: paso robles, california
Posts: 113
Default Re: Carb assembly?

lower the clip on the needle 1 or even 2 slots the eclip is suposed to be on the bottom under the c washer . with your eclip on top that is atleast 1 notch higher in the carb than where it is suppoed to sit so when you put the needle where it is suposed to go you leaned it out. if 1 notch isnt enough and 2 is too much you can put a small washer under the eclip to raise the needle half a notch. HEY!! DO A WHEELIE! hill climber
Reply With Quote