View Single Post
Old 09-12-2008, 01:00 AM
NunyaBidness's Avatar
NunyaBidness NunyaBidness is offline
Motorized Bicycle Elite Member
Join Date: Jun 2008
Location: memphis tn
Posts: 1,061
Default Re: oh no, stripped intake bolt hole!

I had the same problem with one of the bolt holes on my rear motor mount. JBWeld worked great for me and I had NO thread left. I had to tap it out again then mixed up some thin JBW and dripped iit into the bolt hole. When I screwed the stud in all the way the JBW was oozing out the bolt hole. It hasn't been a problem since and I check it regularly.
hope that helps
"I would rather be exposed to the inconveniences attending too much liberty than to those attending too small a degree of it." - Thomas Jefferson
Reply With Quote