View Single Post
Old 09-17-2011, 02:32 PM
mapbike's Avatar
mapbike mapbike is offline
Motorized Bicycle Elite Member
Join Date: Mar 2010
Location: Central Texas
Posts: 5,379
Default Re: Motor Rear Mount Thruster Fixie Progress


You may have a set up that never gives you a minutes worth of trouble which we hop eis the case, and yes you are right, if something does give it will not be the bolts in the engine and that is a big plus for sure.

Once again I hope this works out great in everyway.

Here are some pics of a couple of my bikes that have the carbs sitting at an angle, they run great, no problems.

Peace, map

Originally Posted by xetaprime View Post
Thanx mapbike, that's reassuring. I'd read quite a few posts about keeping it level OY!

I'm hoping the long washers and fixing it with both clamps will take the pressure off- but I knew they would be long doing this... do I like to gamble Also at least if they do snap, it won't be the bolts on the engine...

Best wishes,
Attached Images
File Type: jpg MT bike.jpg (181.8 KB, 203 views)
File Type: jpg Kulana 1.jpg (140.9 KB, 183 views)
I dont always ride WOT, but when I do..I do my best to keep the rubber side down..Ride safely my friends!
Reply With Quote