View Single Post
Old 09-09-2011, 08:13 AM
Ernst's Avatar
Ernst Ernst is offline
Motorized Bicycle Elite Member
Join Date: May 2011
Location: Turlock Ca
Posts: 363
Default Re: Ernst from Turllock Ca

I have a question on the Clutch pin and ball bearing.

I picked up some 5/16 ball bearings but it seems that clutch pin sticks out too far with a bearing in the hole.

Am I being dumb? Is the ball bearing in there all ready?

When I try to put it together it's obvious that it will be pushing the pin.

I think I am not understanding this ball bearing issue..
Reply With Quote