Re: what did you do to your motor bike today?
I made a new clutch plunger for my China girl today (the plunger is between the clutch cam and the marble, inside the drive sprocket). I used a bolt and drilled the end a bit to help it stay on the marble.
I had been unable to adjust my clutch properly for quite a while. I finally figured out that my plunger was a bit too short, from wear or whatever. I found a bolt of similar diameter and cut it a bit longer than my existing plunger. So far, so good.
“You're only young once, but you can be immature as long as you like" -Unknown