View Single Post
Old 08-29-2011, 07:25 AM
dirtyoldcrusier dirtyoldcrusier is offline
Motorized Bicycle Elite Member
Join Date: Sep 2010
Location: Cincinnati,Ohio
Posts: 196
Wink Re: raw 80cc- Project: Gunnabe

Originally Posted by DuctTapedGoat View Post
Hardware kit is for headbolts, manifold bolts, and frame mount bolts mainly. Everything else is fine.

Gaskets - i like to stand by that if you break the seal on a gasket, replace it before you close it up. Black RTV rocks for adding some extra sealing power on paper gaskets.

Idle Screw - get a new one. The screw that's stock has no threads on the tip, and is rounded so as to not get flakes of metal from the slide in the barrel/jets.
Just as Duct Taped Goat says replace the gaskets,,, Check out DAX's He sells whole NT carbs for just under $12.00. Did your kit come with out a adjusting screw on the carb? Any how welcome to the forum, & good luck with your build. I also like the RAW engines, I have three 1 50 & 2 80'S so far no issues... over & out DOC
Reply With Quote