View Single Post
Old 09-01-2008, 07:39 PM
Nomad Nomad is offline
Motorized Bicycle Elite Member
Join Date: Aug 2008
Location: U.S.A.
Posts: 188
Default Re: Sprocket won't fit on Schwinn Cruiser???

Thanks for all the great info, I did use a dremel with a steel cutting tool to ream the hole slightly. I then placed it over the dust cover and used a cable tie tied to a spoke to check for "trueness" all the teeth were about equidistant from the tie so I figure it's "square" in the center.. If I had seen some of this info earlier I would have removed the cover and went from there... thanks to all I'll report on the results when I get this one built....
Reply With Quote