View Single Post
Old 07-10-2011, 09:21 PM
John the Chimp John the Chimp is offline
Motorized Bicycle Senior Member
Join Date: Jun 2011
Location: Simi valley ca
Posts: 81
Default Re: The "If I knew then what I know now" Thread

I would have torn the motor apart and cleaned all the cast flashing. Polished the piston, wrist pin, needle bearings,and rod. I would have port matched the intake,and exhaust. Just would have gone thru the whole motor before the build. Buy and Dial in the dual brakes. Heavy duty axels.Grease the hubs with good grease. A major tune up on the bike its self.
Reply With Quote