View Single Post
Old 07-09-2011, 12:20 PM
culvercityclassic's Avatar
culvercityclassic culvercityclassic is offline
Motorized Bicycle Elite Member
Join Date: Sep 2009
Location: Culver City, Ca
Posts: 2,902
Default Re: Custom Frame For Thumper Motor

Hey LS614

I do ride the bike around a lot and fear getting pulled over but do have a few get out of jail cards to try and use. My favorite run is from my house to the beach which is about 3 miles one way, nice long stretch to open her up. The other day was a family ride with my kids and they just looked. Gota love L.A.


The exhaust is a combination of mig to hold it in place, tig to finish the joints and brazing on the lower silencer area. Before I had the mig/tig available all my exhaust were brazed. I really like that look and try to mix it up when I can.

On a note: when disconnecting the low oil sensor I recommend removing the sensor from the case and tapping that hole to seal it properly. I did not do that and now have to pull the motor to complete this. If you chose otherwise it will become a leak. You are warnedů.
Attached Images
File Type: jpg P7080059.JPG (362.8 KB, 177 views)
File Type: jpg P7080061.JPG (395.2 KB, 213 views)
File Type: jpg P7080062.JPG (391.9 KB, 163 views)
Reply With Quote