Proper Break-in Procedure with Opti 2?
For starters, I have read that whole "100:1" thread, but I still have a couple of questions. I know that the end goal is to run the engine at a 100:1 mix, but should I break-in the engine on a different oil? If so, what oil and what ratio?
If in fact I should use Opti 2 for breaking in the engine, should I just use a 100:1 ratio from day 1, or should I start at a higher oil concentration (perhaps 75:1 or even 50:1)?
Anything else I should know about using this oil in a 66cc two stroke?