View Single Post
Old 06-23-2011, 03:00 PM
ex42k9j ex42k9j is offline
Motorized Bicycle Senior Member
Join Date: Aug 2010
Location: Location: Location: Location:
Posts: 65
Default Re: Last set of problems

Well I think I know what to do with the throttle cable. Open the top of the carb, remove the spring, the needle looking thing and the brass cylinder. Then thread the throttle cable through the top screw and spring and put it in the opening in the cylinder (kinda like how the handlebar thing was done) and screw it all back in.

When I move the throttle on the handlebar I can see inside the carb the cylinder is lifting up.

What about that screw on the side? If i screw it in it makes the cylinder stay raised a little.

I read that post and still cant figure out how I am suppose to connect the kill switch wire to the cdi/engine wire as they are already connected and I dont see how to hook a 3rd one to it.
Reply With Quote