Thread: Mill/Lathe
View Single Post
Old 06-22-2011, 09:46 PM
Greg58's Avatar
Greg58 Greg58 is offline
Motorized Bicycle Elite Member
Join Date: May 2011
Location: Newnan,Georgia U.S.A.
Posts: 2,621
Default Re: Mill/Lathe

Dan the slide device with the center punch comes out on most and a chuck goes in, can't tell if this machine has that feature.
Went back and looked again, looks like the anvil has a mic. on it so if the center pin comes out you can drill the shaft.
Your results may not be the same,Greg

Last edited by Greg58; 06-22-2011 at 09:51 PM. Reason: more info
Reply With Quote