Thread: Mill/Lathe
View Single Post
Old 06-22-2011, 07:45 PM
Dan's Avatar
Dan Dan is offline
Join Date: May 2008
Location: Moosylvania
Posts: 11,850
Default Re: Mill/Lathe

First (prolly dumb) question. I want to make a part that enlarges the predators drive shaft Dia. 5/8 to 3/4. Also lengthen it by drilling out a 3/4 round stock with a 5/8 bit then milling a slit in for the keys. One on the drive shaft and one for the keyway on the sleeve/part.

How do I go about drilling it out? In researching this tool, turns out (big time bummer), it cant do threads? I thought I could add a chuck to drive a shaft in to drill it out. (Told ya might be a dumb question) Or am I resigned to using the drill and try and center it?
worst apocalypse ever
Reply With Quote