View Single Post
Old 08-27-2008, 09:12 AM
Nomad Nomad is offline
Motorized Bicycle Elite Member
Join Date: Aug 2008
Location: U.S.A.
Posts: 188
Default Re: Brand new engine has hole in cylinder near stud. :(

Thanks again for the input. eDJ I was going to take the advise of filling the hole with JB weld or as Macaddict suggested, some "fast steel", but I was concerned that it would stick to the stud when it hardened and then if I ever did have to take the jug off it would be "stuck" due the repair... I havent run the engine yet so, what is your feeling on that... If I did the repair, would you suggest taking the jug off to do it?.

P.S. I did get my missing parts from the vendor by priority mail 2 days later. So I would say he's shown a willingness to make sure a customer is taken care of.


Last edited by Nomad; 08-27-2008 at 09:18 AM.
Reply With Quote